|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-22-2002, 02:48 PM
|
|||
|
|||
|
new wheels
my cuurent wheels are 14" on my mirage but i want to put in some 16" instead, would i have to do something to the axle to make sure everything goes alright? please help :] thanks!
__________________
-ems 
|
|
#2
05-26-2002, 07:13 PM
|
|||
|
|||
|
If your just gonna swap rims without a lowering job, there should be no rubbing involved. UNLESS of course the rims you get has an offset very different from the factory. I don't know the factory offset for the mirage, but I would not deviate from that number by more than a couple mm. There should be no other concerns, but make sure you get an alignment after you put your rims on.
Good Luck Maurice
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
