|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Exterior | bodykits | Lighting When your ready to showoff that 'H' ride, here's your forum! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
10-29-2004, 12:57 PM
|
|||
|
|||
|
HELP! Need help on replacing a bulb..
This is NOT like the normal stock bulb. I have a set of 92-95 civic 2dr 1-piece halo projectors. The driver's side low beam blew out, so I tried replacing it. I took the whole headlamp out, removed the rubber cap on the back, removed the pin, and tried taking out the bulb itself. The problem is..... the wire is attached to the bulb and it looks impossible to remove the bulb. IS THERE A WAY TO TAKE IT OUT?? Need help quick!
|
|
#2
10-29-2004, 03:19 PM
|
|||
|
|||
changing bulb help!
Ok, so I have a 98 honda civic ex.....bought it with the angel eye/halo ring lights.....the headlight burned out.....what does it take to change the bulb????? a mechanic???? Can anyone out there help me?
|
|
#3
10-29-2004, 06:50 PM
|
||||
|
||||
|
Re: HELP! Need help on replacing a bulb..
check and see if there is a connector somewhere on the wire. i checked my projector when it blew and it wasa strange bulb with awire in a white sleeve on it. at the end of the sleeve was a connector its pretty simple to replace they sell the bulb at wal*mart
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
