|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
10-20-2004, 11:41 PM
|
||||
|
||||
wiring for DIC
I am trying to put a 97GTP DIC into a 98GT that has the standard DIC.
I have both connectors, but when I connect the new DIC I get flashing zero's. I think that I am not getting a signal from either the PCM or the one telling the engine speed. The new DIC came with the connector in it and the wires cut off and there are two extra wires, one is probably for the boost gage and the other may be the engine speed. I know someone out there has a service manual for the 97GTP that has the wiring diagram. Can you tell me where the PCM and Engine speed monitor (not sure of the acronym)wires go into the connector. 
|
|
#2
10-24-2004, 02:08 PM
|
|||
|
|||
|
let me know if you didn't get the email, I can always break it down into smaller emails.
|
|
#3
10-24-2004, 10:13 PM
|
||||
|
||||
|
I got some diagrams sent to me on the 21st. Not sure if it was from you or not. It seems that the wiring is the same. I'll either have to find time to trouble shoot this or just go back to the boring DIC and sell the digital
one.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
