|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
10-03-2004, 06:25 PM
|
|||
|
|||
|
lt1 rods
Hello,I have a 95 lt1 engine that I have just gotten out of the machine shop. I started assembling the bottom end and noticed that the #1 and #2 rods have been pressed on the pistons differently than the other 6. I am not sure if these 2 are correct or the other 6 are. Can any one help me out with this.
Last edited by fastmohave; 10-03-2004 at 07:40 PM. 
|
|
#2
10-03-2004, 07:13 PM
|
||||
|
||||
|
Re: lt1 rods
Can you post some pics of them?
__________________
97 Z28 C.A.I. Edelbrock shorties,all free mods,Borla's,MSD,LT4 timingchain, 1.6r/r,LT4 cam, NGK,p&p heads,ported maf ,52mmTB adj fuelpressure reg.,373's,pcm tune by pcmforless, all poly bushings,spohn t/a, s/t brace, etc. What I don't have..no egr no air pump and no cats Well dip me in chocolate and throw me to the lesbians!!!!! 
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
