Please Tensioner Pulley Help

Mackian333 · #1 10-03-2004, 01:11 PM

I cannot get my tensioner pulley back in the slot that it came out of. I just installed a new Alt and belt and Pulley, and Now the little groove will notfit back into the slot.

Anyone have a diagram

Mackian333 · #2 10-03-2004, 01:26 PM

I already had a new belt on. When i installed the tensioner pulley back on trhere was a slot wher there was a groove for it to go in but it was at an angle and the belt ould not even. I will try my old pulley and belt today to see it that works. What elese can I do?

I need my truck to work for tomorrow.

BlazerLT · #3 10-03-2004, 01:39 PM

Take a pic of what you are talking about.

Mackian333 · #4 10-03-2004, 01:55 PM

<img src="http://i20.ebayimg.com/02/i/02/1e/a9/08_1.JPG"/img>

on the side below the alt

BlazerLT · #5 10-03-2004, 04:35 PM

No, I need a pic of what's wrong with YOURS.

Mackian333 · #6 10-03-2004, 10:28 PM

i Don;t have a camera.

Also i found out what was wrong. I needed to torque the tensioner pul;ley back to put tension on the belt. The Guy at Kragen told me waht i neeeded to do now its working fine.

Thanks alot

Mikado14 · #7 10-04-2004, 09:55 AM

Sounds as if you were attempting to install the tensioner along with the belt at the same time. "Ain't gonna happen"

BlazerLT · #8 10-04-2004, 02:08 PM

Tehehehe.

POST REPLY TO THIS THREAD