Programming for 1997 Avalon remote

[bc7359]

I am looking for instructions for programming my 1997 Avalon remote. I have two remotes for this car and both are "dead" (new batteries in one). I can't believe the dealer wants so much to program this thing. Anyone have the instructions?

[stephensclan]

How do do this depends on a lot of things, most significantly if the remote system is factory or was installed by Toyota after coming to the US (at the dock). I have the same problem and found this Tech Service Bulletin to help explain at least where to look.

http://rav4world.com/tsb/EL010-01.pdf

[aa6]

I found this out from an ebay auction. Here is the link. I have not personnally tried this, but I doubt this business owner would have any reason to post bogus material. Good luck...let us know if it works or doesn's work.

http://www.spotco2.com/9597_avalon.html

Programming for 95-97 Avalon remote

1. Remove key from ignition
2. Locate bulb failure warning module in truck near left trunk
hinge and disconnect electrical connector.
3. Jump pins 2 & 10 of connector with short wire or paper clip
4. Door locks will cycle
5. Press any button on remote keyless entry entry transmitter
6. Door locks will cycle
7. Repeat steps 5 & 6 for another transmitter
8. Remove jumper from connector and reconnect to module

NOTE: A max of 2 transmitters can be programmed to a car

NOTE: Entering programming mode erases all previously
programmed transmitters.