|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
09-07-2004, 05:55 PM
|
|||
|
|||
|
92 S-10 oil pan replacement
My 92 S-10 with the 6 cylinder has a really rusty and leaking oil pan. I tried to change it once a couple years ago and found that it wasn't going to happen without some major work. I've been patching and patching with JB weld and it has helped, but I think it's time to do it right now. Anyone done it. I assume you have to lift the engine quite a bit. Other threads say you don't have to pull the engine on a 2 wheel drive which is what I have. The truck has only 32K miles, but is rustyer than all get out. Help.
|
|
#2
09-07-2004, 07:04 PM
|
|||
|
|||
|
Re: 92 S-10 oil pan replacement
is there a subframe covering the oil pan? if there is, most likely you will have to lift the engine (not remove) to get enough clearance to get the oil pan out.
|
|
#3
09-07-2004, 11:01 PM
|
|||
|
|||
|
Re: 92 S-10 oil pan replacement
If it's a 4x4 you will probably have to pull the motor, I know that I did.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
