????'s about sr20 swap into S13

[Josh95cx]

I have a 89 240sx hatch with the sohc KA, I was wondering if i can use the sohc MAF in my sr20det swap, Also I was wondering what clutch to use. The last question is if I have the motor,tranny, new manifold and dump pipe, ecu, ignitor, harness, FMIC, new walbro fuel pump, B.o.V, boost controller, what else do I need? Thanx this is my first nissan, and i wan't it done right.

[Josh95cx]

Also I have a 5-speed and plan on getting a LSD, and using my stock driveshaft.

[winstonusmc]

you will need some sort of piping for the heater hose. Check autozone on pipes that will work. The stock SOHC MAF will work, thats what I run. You can stick with the stock radiator, it is the same thickness as the SR one, I measure them both. Or upgrade to a Koyo, $200 for copper or $300 for aluminum.There are many clutches out there that are made for the SR, check enjukuracing.com. They have good prices. Dont forget to upgrade your whole exhaust, not just the downpipe. Good luck

[Josh95cx]

I have got a hose kit from heavy throttle, and a act clutch, any mods to the stock sohc maf to use it with the sr?

[racer98]

Originally Posted by Josh95cx

I have a 89 240sx hatch with the sohc KA, I was wondering if i can use the sohc MAF in my sr20det swap, Also I was wondering what clutch to use. The last question is if I have the motor,tranny, new manifold and dump pipe, ecu, ignitor, harness, FMIC, new walbro fuel pump, B.o.V, boost controller, what else do I need? Thanx this is my first nissan, and i wan't it done right.

too much of my shock yes you can use a SOHC MAF for it