|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Engineering/ Technical Ask technical questions about cars. Do you know how a car engine works? |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-07-2004, 11:44 PM
|
|||
|
|||
|
327 crank,,,350 block
What would that do fo me??? i've got a 350 and i need 1000-5000 RPM range,,,if i put a 327 crank in it. gimme ur opinions
__________________
Black 79' Monte Carlo Built 350 TH-400 trans. 3.73 limited rear end Edelbrock IAS Shocks 14" Cragar Keystone Klassics 60 wide BFGoodrich Radial T/A Not too bad for $1500 
|
|
#2
08-08-2004, 12:34 AM
|
|||
|
|||
|
It would give you a 327....
A 350 will run up to 6000 rpm with very little changes needed. 23 inches, is after all 23 inches... plus head for head, you will lower compression by installing the shorter crank - you would need to find smaller chambered heads
|
|
#3
08-08-2004, 12:05 PM
|
||||
|
||||
|
Re: 327 crank,,,350 block
Quote:
__________________
|
|
#4
08-08-2004, 06:31 PM
|
|||
|
|||
|
Re: 327 crank,,,350 block
Thanks
__________________
Black 79' Monte Carlo Built 350 TH-400 trans. 3.73 limited rear end Edelbrock IAS Shocks 14" Cragar Keystone Klassics 60 wide BFGoodrich Radial T/A Not too bad for $1500
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
