|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Off-Topic Talk about anything other than cars. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-03-2004, 01:15 AM
|
|||
|
|||
|
Need help with wiring my NEONS through my door pins
This is my first time using this so please help!
Well i would like to know if there is a way to wire my neon lights so that it is triggered throught the door pin, so that my car lights up when i open the door, the tricky part is (or to me it is), i would still like to have a master switch which can deactivate the whole thing since this stuff is not legal in my state. I would also like to know how i can remove my front bumper, i was thinking about going to home depo and buying some grills and making my own. please help!! 
|
|
#2
08-03-2004, 01:57 AM
|
||||
|
||||
|
Re: Need help with wiring my NEONS through my door pins
makin your own bumper?
__________________
-1997 Eclipse Spyder GST |Stock| -1990 Eclipse GSX |ACL Main & Rod Race Bearings|Balance Shafts Removed|ARP Head Studs|Cometic HG|FP 20g TDO6H|EPROM Chipped (stutter box 5k, fuel comp.)|PTE 680cc inj.|Walbro 255 HP Fuel Pump|Autoteq FPR|SAFC 2|FMIC|2g MAF|Dejon Tool Hard Pipe|Greddy Type S|MBC at 17PSI|Ported 2g Exhaust Manifold|02 Housing w/ Tial 38mm WG|Full 3inch Exhaust w/ Y-pipe Cutout|Fidanza Flywheel|ACT 2100|4 Bolt LSD Rear|Poly Mounts|KYB AGX Suspension|Roll Bar|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
