|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Off-Topic Talk about anything other than cars. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
07-25-2004, 08:58 PM
|
||||
|
||||
Water Temp Gauge Install
I bought a Mechanical Autometer Water Temp Gauge and was wondering where a good place would be to tap the sensor into. I have a 90 Eclipse GSX. It says to tap into the thermostat housing, but we all know how crowded that is. Would I be able to remove my coolant sensor and put this one in its place?? Or do I have to find a different spot to tap into. Thanks for any help!
|
|
#2
07-26-2004, 03:15 AM
|
|||
|
|||
|
Re: Water Temp Gauge Install
There are typically 2 sensors for coolant temp. One for the guage, and one for the ECU. Find the one for the guage (single wire, not two, IIRC) and replace that one.
__________________
Kevin Jewer RWD Talon - 7.92 at 180 Mightymax - 10.7 at 125
|
|
#3
07-26-2004, 02:44 PM
|
||||
|
||||
|
Re: Water Temp Gauge Install
the greddy temp sensor splices the radior hose and the sensor fits in between, its ez to install
[img] http://projectgsx.com/pics/mods/gaug....jpg[/img]
__________________
 1998 Eagle Talon TSi AWD 6 Bolt Swap \ DSMLink V2.5 \ ACT 2100 clutch \ PTE SCM 61 \ Forge MBC@28psi \ VPE O2 Housing \ MR Downpipe \ Thermal R&D Cat-Back \ Tial 38mm WG dumping off O2 \ FMIC w\ in short route \ AFPR setup/walbro 255hp \ PTE 880cc injectors \ Crower Ti retianers \ Crower Springs \ Crower 64414 (stage 3 race) cams \ Ferrea valves \ 3.5 bar MAP \ PLX M-300 Wideband
|
|
#4
07-26-2004, 02:56 PM
|
||||
|
||||
|
Re: Water Temp Gauge Install
Cool, thanks!
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
