|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Let's get Technical! Discussion for hardcore in-depth motor heads! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
07-10-2004, 01:38 PM
|
|||
|
|||
|
d16z6 to either H22 or GSR?
I have a d16z6 in my car right now with no mods and it goes really hard but i was lookin and either an h22 or a gsr motor for the swap and i have a lot of room i could go with an S2000 motor and make it a rear wheel drive civic hatch
 ??? lol it would be different non the less lol
__________________
I get asked why i drive a honda and i say...... Cause its faster than yours 
|
|
#2
07-10-2004, 02:55 PM
|
||||
|
||||
|
Re: d16z6 to either H22 or GSR?
If you do road races or like to hug turns at high rates of speed i'd recommend you go gsr. If you're looking for ¼ times and don't mind understeer in daily driving time then the h22 will be good. S2000 motor w/rwd conversion would be "different" (been done before) but it will also be very expensive with all the fabrication. Unless you have a ton of $ to burn, time to do it, and knowledge of how to do it; I'd say stick with the gsr or h22.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
