question for body work expert

henry matyjewicz · #1 06-24-2004, 12:19 AM

what would I have to do to fit these on a 95 civic coupe? They're invader side skirts from a 94-97 accord sedan. There aren't any flaps on the ends, they run straight across the bottom.
http://www.visracing.com/catalog/pro...b3bf08a5490d6c (click pic to enlarge)

henry matyjewicz · #2 06-25-2004, 02:17 AM

I'm not sure how hard it'll be but I know it's not impossible. Any feedback would help.

kicker1_solo · #3 06-25-2004, 11:19 PM

You'll have to do some cutting and fiberglassing, that's a tough project, not worth your time in my opinion.

b16 crx kid · #4 07-01-2004, 08:54 PM

dont they make those same sideskirts for your car?

henry matyjewicz · #5 07-01-2004, 11:23 PM

same name, different design.

Hey Kicker, can you use resin without the fiberglass mesh? For small holes made by screws.

RSLaser · #6 07-02-2004, 08:34 AM

resin is really intended as a glue. use some cheap JB weld to fill in the holes.

92'SiHatchBack · #7 07-03-2004, 03:25 PM

well first cut it to the length then you could have someone do some good bondo look if you want them molded i say go for the molded look its always better more time and money but it looks better.

henry matyjewicz · #8 07-03-2004, 10:51 PM

Quote:

Originally Posted by 92'SiHatchBack

well first cut it to the length then you could have someone do some good bondo look if you want them molded i say go for the molded look its always better more time and money but it looks better.

the skirts don't come with flaps. so they really can't be molded to the panels. thanks for the advice.

RSLaser, what's JB Weld? Never heard of it.

POST REPLY TO THIS THREAD