|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
01-23-2002, 11:27 PM
|
||||
|
||||
|
How do you pull codes from a 92 LX?
We're trying to get the error codes off of my friends Accord. We took off the kick panel and can see the diagnostic port. The service manual says to bridge the two sides with a wire or paper clip. The thing is, there are three holes! The picture in the book only shows two. And only speaks of two. Can anyone help us out?
Thanks, Dave 
|
|
#3
01-24-2002, 02:41 AM
|
||||
|
||||
|
answered to it on hondastyle. in fact there are 3 holes and only 2 wires. :frog:
__________________
hondaman-iac @ HondaStyle 92 ACCORD LX -- powered by a blown F22A1 Current Mods: *rear lower tiebar *AEM CAI *Koni Yellow Struts *Ground Control coilovers *Energy suspension bushing kit *front upper strut bar *rear upper strut bar PureHonda member since April 2001
|
| |||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
