|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
06-14-2004, 09:21 AM
|
|||
|
|||
|
Motor Mount 88 V6
I need to replace the right (passenger side) motor mount on my 88 3.8 V6. I crawled inder and around it this last weekend but how to get to the rear bolt where the mound attached to the block wasn't obvious to me. Any suggestions how I do this?
__________________
Everyone has value. Personally I serve as a bad example! 
|
|
#2
06-17-2004, 08:31 AM
|
|||
|
|||
|
Question changed
Last nigh I got in my driveway, heard a strange noise, Opened the hood and there was steam gushing from behind the pulleys so I guess it blew the water pump gasket. Time to get another car and decide what to do with this one. It ran so sweet too except using a little oil and a noisy RH motor mount.
I'm inclined to pull the motor totally and look into rebuilding it (New seals and gaskets) if I prove it is just the water pump gasket that went. I guess I'm lucky it got me home before that blew out as I travelled 45 mile from work to home. If not maybe another motor, maybe scrap it??
__________________
Everyone has value. Personally I serve as a bad example!
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
