|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Remote Control Cars Questions, comments or discussions on the wonderful little vehicles. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
06-13-2004, 08:36 AM
|
|||
|
|||
i need help
rite i have got a tamiya subaru impreza wrc 2001 thats running on nicad
for the remote control i have got a acoms techniplus ap-202. when i turn the switch on the motor just spins on its own.The remote control doesnt do anything.Everything has been put in properly all the wires have been put on properly. this is my first build of an r/c car so i dont really no much about them any ideas whats up with it???? thanxs jon boi 
|
|
#2
06-13-2004, 09:38 AM
|
||||
|
||||
|
Re: i need help
Ok 1st, on my Futaba pistol grip, there is a switch to make the "TH.TRIM" to either "R" or "N". There is proably one on urs too, make sure thats set to "N". Then there is also a dial or sumsort label "TH.TRIM". settin the dial alll the way to one end will make the wheels spin by itself, and setting the dial at other end will make the wheels just completely stop and u use the throtle to give/takeaway juice to ur car, try playing with those settings and see what happens, it should fix it, if not come back here
|
|
#3
06-13-2004, 11:00 AM
|
||||
|
||||
|
Re: i need help
What chassis? What ESC?
__________________
-Mike AF Director of Media / Photographer  [email protected] | AutomotiveForums.com | Flickr Gallery
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
