|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-07-2004, 01:11 PM
|
|||
|
|||
|
sorry about the already covered question(if it was)
but i need to lower the back of my 86 si hatch 2 inches and i looked through 21 pages here and a few manufacturers sites and the best i found was 1 inch using 1st gen wagon springs. is that the best i can get. now my other problem, i want higher spring rate torsion bars. where can i find them. well i hope someone can help cause i am lost
|
|
#3
04-07-2004, 02:48 PM
|
||||
|
||||
|
Re: sorry about the already covered question(if it was)
read this
 http://www.automotiveforums.com/vbul...91&postcount=6 i thought this had it's own thread at one point but i'm not sure
__________________
~Attention! if you are thinking about a D16A1 swap for your Civic/CRX and don't know where to start go Here. Thanks.~
|
|
#4
04-07-2004, 11:49 PM
|
|||
|
|||
|
Re: sorry about the already covered question(if it was)
thanx cvcc wagon i looked through the first 21 pages of threads and didn't see it. i must have been lookin somewhere else in the room at the time
|
|
#5
04-08-2004, 12:00 AM
|
||||
|
||||
|
Re: sorry about the already covered question(if it was)
well that thread does nt have an obveous name for what you are looking for, i twas hopeing to put all that info into a faq but igor has not goten back to me...maybe it's time for another PM
__________________
~Attention! if you are thinking about a D16A1 swap for your Civic/CRX and don't know where to start go Here. Thanks.~
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
