|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
03-15-2004, 01:45 AM
|
||||
|
||||
|
intakes for V6
All right...you all probably already have intakes on your cars...but the only intake I can find is the Weapon R intake (not cold air or short ram), all the others are for the 4 cyl. MX3. Where'd yall get urs?
|
|
#2
03-16-2004, 02:07 AM
|
|||
|
|||
|
PRM makes a good one...
http://www.prmracing.com/products.html other then that, just go to mx-3.com and check out the aftermarket section, it's got links to tons of stuff...
|
|
#3
03-18-2004, 02:35 PM
|
||||
|
||||
|
Re: intakes for V6
Is it better than the Weapon R intake? I've never heard of PRM.
|
|
#4
03-21-2004, 10:43 PM
|
||||
|
||||
|
weapon r is crap, prm is good, custom is better
 go take a look at mine http://www.cardomain.com/memberpage/211008/4
|
|
#5
03-22-2004, 02:43 PM
|
||||
|
||||
|
Re: intakes for V6
My friend offered me an acura intake, I don't know what kind, but it was cold air, so I researched whether or not it would fit, and I ran across your car domain page. I decided that I didn't want to move the resevoir. But, that might be the cheapest choice.
How much did you spend on your intake? Cause, if the $180 for the PRM is the cheapest it gets, then I'll just wait until I swap in the KLZE to get any mods.
|
|
#6
03-23-2004, 12:57 AM
|
|||
|
|||
|
Re: intakes for V6
it's probably smarter to just wait til you get your ZE...you could always go the SUPER cheap route....make it yourself out of PVC pipe....it's been done before. i dont know if there are directions on how to make it, but i've seen pvc intakes before. that one would probably run you less then 100(including the cost of a filter)
|
|
#7
03-23-2004, 03:16 PM
|
||||
|
||||
|
well guys...you can really go cheaper than 30$
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
