|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
02-21-2004, 07:14 PM
|
|||
|
|||
1985 Suburban Steering Column with Tilt
I have a broken Ingnition Rack inside the column and it is still hooked to the ignition actuator. I am trying to get the broken piece out. I have the column apart down to the tilt portion, but can't figure out how to get this part off of the column. There are two tilt swivel pins on either side and the tilt locking portion on top. I am missing something and the Chiltons book does not tell how to specifically do this.
I need some help. Thanks, Blmitche 
|
|
#2
02-22-2004, 08:27 AM
|
||||
|
||||
|
Re: 1985 Suburban Steering Column with Tilt
You will need to pull the 2 pins out to remove the tilt housing (assuming you have removed the steering shaft already).
There is a tool for pulling those pins..or you could use a slide hammer.
__________________
Why do you never have enough time or money to do the job right the first time, but enough time and money to do it again? Got all the certifications 25 years ASE Certified Master Technician GM WCT Yea..I work at a DEALERSHIP....got a problem with that? Want to diagnose cars like the Pros? FOR SALE: OTC Perception 2 channel Labscope (badged as a Matco Reality) This is my personal labscope that I use to diagnose waveforms, like new, comes with leads and training video PM Me for details
|
|
#3
02-23-2004, 07:39 PM
|
|||
|
|||
Thanks
I figured out how to do it. I have it halfway back together now, but one little piece of spring steel fell out of the turn signal housing while I was pulling it. I can't yet figure out where it goes. I need a part break down of this switch. Do you know where to get one?
blmitche
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
