|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-19-2004, 11:28 AM
|
|||
|
|||
1 toe out
For the b16a swap i had to install 91teg hubs and knuckles (spline count of driveshafts) and I didn't change any other suspension related parts. I replaced my 13" wheels with 14" wheels and can visble see that the passenger side wheel is toe'd out between 1/2"-1", driver side looks ok. The ball joint on the tie rod end was a bitch to get tight but nothing else gave me any trouble during the swap. Any suggestions? I do plan to get it aligned I just don't want to trash the tire and rim getting there.
91 CRX HF B16a 
|
|
#2
02-19-2004, 01:05 PM
|
||||
|
||||
|
Re: 1 toe out
Then go get it aligned
__________________
Sponsored by: KAM Racing Sports, Falken Tires, Finish First Polish, Brady's High Performance, Taggart Performance Engineering, Rotora Brakes Autocross is: 90% driver, 5% car, & 5%  CRAZY MOJO!Autocross Help Page Buy my Civic parts!
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
