|
Re: Camber, Caster Alignment?
Yes there is.. but from what I understand it is a hell of a job to adjust it. You must remove the whiper shroud, whiper and whiper motor, drill out the rivits that are holding the strut from adjusting then losen the 3 strut mout nuts and adjust it. If you are going to try this yourself you will never get the right camber/caster. If you take it to a front end shop they can do it but it will take them about 3 hours worth of work just to get to the adjustments. So best bet is to do all the removing of the whiper and such yourself then drive it to a front end shop and have them do the adjusting then you finnish the job by putting it back together yourself. It will save you about 6hours in labor if you get everything ready for them to set the camber n such.
|
11-30-2003, 08:52 PM
