|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
10-07-2003, 11:40 AM
|
|||
|
|||
clutch help
Iv'e worked all day on this with no luck, my clutch will not fully disengege the master cylinder and slave cylinder were rebult all lines were checked and good. I can pry on the arm as far as i can get it and then pump the clutch and it will disengage but one I let off and push again it wont. any advice whould be help full
|
|
#2
10-09-2003, 11:37 AM
|
||||
|
||||
|
Don't mean to take away from this board.. but you may want to try over at http://www.fiero.nl/cgi-bin/fiero/Ul...i?action=intro might get a faster reply
|
|
#3
10-28-2003, 09:25 PM
|
|||
|
|||
|
lol sorry so long to post
i had same problem the push rod on the clutch by the trany wore out on mine and i put a small socket over it.... worked for me
__________________
Here's my Beast!!! 
|
|
#4
10-30-2003, 10:46 AM
|
|||
|
|||
|
think i found it
well i found out that the clutch master cyliner is bad. im going to rebuild it, hopefuly that fixes my problem. i also replaced the slave cylinder and push rod.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
