|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| WIP - Motorsports Post topics for any "Work In Process" motorsports vehicles in this sub-forum. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
02-11-2024, 12:47 PM
|
||||
|
||||
|
Mancuso Greenwood Corvette - Watkins Glen 1977
This is a 1/43rd resin kit by Starter from the early 90's.
The body casting was pretty clean compared to the other variants of this casting I have. (Must have been a low mileage mold.) But it had an inordinate amount of holes that needed to be filled. I'll take that issue over a crusty worn out mold that can really mess up details. At this point the brass parts have been attached and the stance has been adjusted. It's ready for primer.  
|
|
#2
02-11-2024, 06:12 PM
|
||||
|
||||
|
Re: Mancuso Greenwood Corvette - Watkins Glen 1977
I mixed the light blue using old Testors Pla enamels; 1108 Light Blue and 1145 Gloss White. Shot it last night.
|
|
#3
02-14-2024, 04:37 PM
|
||||
|
||||
|
Re: Mancuso Greenwood Corvette - Watkins Glen 1977
The decals respond well to a hairdryer and decal solvent. They are not brittle but they are thin. I had to cut the front fenders and rear end decals into multiple pieces to deal with the contours. It took a good 2 and a half hours to apply these 6 decals.
 
|
|
#5
02-22-2024, 12:33 PM
|
||||
|
||||
|
Re: Mancuso Greenwood Corvette - Watkins Glen 1977
Thank you Potsie!
Ready for final assembly…  
|
|
#7
02-23-2024, 09:31 AM
|
||||
|
||||
|
Re: Mancuso Greenwood Corvette - Watkins Glen 1977
Thanks!
I finished it last night. Will share the finished photos later today after the sun comes up and I can shoot it.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
