|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
06-17-2003, 10:34 AM
|
||||
|
||||
wanna install power locks on my '92
Aight you guys, time for another DIY-type question:
So I've got this muscle ca...err 92 DX Hatch, I get the two confused, and I wanna put power locks on the beast. I bought some actuators for the doors for like $40 but when I finally ripped the door apart I found the bar for the locks moves horizontally instead of vertically and it appears the actuator is designed for vertical movement. Anyone done power locks on their civic? How'd you do it? Side note: what would it take to get EX doors and fit them to my car and get the locks and windows working.... THANKS! 
__________________
95 Civic Si - Thunder Grey Exterior -Performance: B16A, JR supercharger @ 9 psi, JR FPR, Tokico 5-wy Adjustable Shocks, Eibach springs, F/R strut and swap bars -Audio: Alpine 9815, 3-way component Pheonix Gold speakers 
|
|
#2
06-17-2003, 12:52 PM
|
|||
|
|||
|
Hey there, I just did power door locks on my civic last week. You'll need 2 actuators, 2 SPDT Relays with 5 terminals, and a momentary switch in addition to enough wires to run everything. Yes, you can install actuators for a horizontal pull. If I get a chance, I'll try to get a picture of what mine look like. For now go to this site:
http://www.the12volt.com/installbay/...=wire+a+switch This is my post in another forum that explains how to wire your locks.
|
| |||||||||||||||||||||||||||||||||
 |
POST REPLY TO THIS THREAD |
 |
|
|
