-
Grand Future Air Dried Fresh Beef Dog Food
Air Dried Dog Food | Fresh Beef

Carnivore Diet for Dogs

Go Back   Automotive Forums Car Chat > Jeep > Cherokee
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 06-12-2003, 03:29 PM
tjganger tjganger is offline
AF Newbie
 
Join Date: Jun 2003
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Send a message via AIM to tjganger Send a message via Yahoo to tjganger
problem with my 88 cherokee

i have an 88 cherokee i was driving it with a bad clutch the day i was going to replace the clutch it was acting up not going over 2000 rpms when warm then it would get more r's if i let it cool for a few minutes anyhow i replaced the clutch thinking i could troubleshoot it later then i got the clutch in and it wont start at all no pluse to the injectors and no spark to the plugs please help i love my cherokee (has the france 5 speed transmission in it with the in line 6 )
Reply With Quote
  #2  
Old 06-19-2003, 05:55 PM
94XJSport 94XJSport is offline
AF Newbie
 
Join Date: Jun 2003
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
Thumbs up

Check you CKP a.k.a. your crank position sensor, or TDC sensor. This is the only sensor that will keep you from getting any pulse to your coil.
You had to have disconnected it to remove your tranny, so you may have not reconnected it.

Good luck!
Reply With Quote
  #3  
Old 06-20-2003, 08:58 AM
tjganger tjganger is offline
AF Newbie
Thread starter
 
Join Date: Jun 2003
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
Send a message via AIM to tjganger Send a message via Yahoo to tjganger
i even tried raplacing it so i know it is plugged in
Reply With Quote
  #4  
Old 10-25-2003, 02:54 PM
JScot JScot is offline
AF Newbie
 
Join Date: Oct 2003
Posts: 8
Thanks: 0
Thanked 0 Times in 0 Posts
I have an 88 with the same problem. I Cleaned the IAC last Monday and it ran. I then changed the plugs and it hasn't started since. There's no power to the coil. I checked the Crank Shaft Position sensor like it says to do in Haynes and I recieve continuity between A and B. Haynes says there should be no continuity so I got a new CKP. I checked the continuity of the new CKP and it too has continuity between A and B so I haven't installed it. If you got yours running, can you let me know what it needed?
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Jeep > Cherokee


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 03:41 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts