|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
||||
|
||||
|
engine conversion
i currently have a 1990 Mustang Convertible Lx that i bought with 160,000 miles on it. i was hoping to change the engine over to a 5.0L V8 but wasnt sure what i really needed, or where to look, any help would be greatly apprectiated.
|
|
#2
|
||||
|
||||
|
You need to find a donor car to get the engine trans and wiring harness/computer and grab the rear end out while your at it. Its a fairly common swap if you check around on the internet.
__________________
More photos and Info/website! 1994 Cobra -off road h-pipe -superchips power chips -mac cold air induction -BBK aluminum underdrive pullies -pro-m 75mm bullet MAF -18" konig wheels with nitto 555 zr tires -Ford Racing 65mm throttlebody -Ford Racing king cobra clutch -Ford Racing 3:73 Gears -Ford Racing Aluminum driveshaft -Bullit suspension/ springs,shocks,struts -Aubrun HD limited slip Diff. 2002 subaru Impreza RS - stock 1989 Toyota pickup 4x4 -K&N
|
|
#3
|
||||
|
||||
|
Yes, this is a very common thing to do. I'm actually contemplating it myself on my notch. The best way to do the swap is to get a donor car like 94svt5.0 suggested. There will be a lot of things that should/need to be changed. It will take time, but can be done if your mechanically inclined and are willing to learn a little bit.
Here's a list if things that need to be changed right away, just to be able to make the car drive. -motor -motor mounts -fuel lines -wiring harnesses -computer Now here's a list of things that should be changed for the sake of safety and longevity. -trans -rearend -all suspension components -whole brake system -driveshaft -wheels Hope this helps some. -Craig
__________________
[size=1]-1950 Ford Custom, flathead V8
-2013 Ford Flex -1999 Ford F150 |
|
#4
|
|||
|
|||
|
i would go with a pre 94 mustang as a doner car. The 89-93 cars would be the best. 94-95 used different headers, distributor, intake manifold, throttle cable, ecu, wiring harness, and mainly accesories, and accesorie brackets.
any questions please e-mail me
__________________
My Cars: 1995 mustang Gt with 1000hp potential, and over 600rwhp on the streets 1991 Sentra SE-R with Jim wolf cams and ecu. Place racing CAI, Nissan 300zxTT injectors and fuel pump, Unorthadox pullies, NOS 100 dry shot. 1993 Nissa 240SX: Currently planning out and getting parts to do a RB26dett swap with a Rb25 transmission I have had many mitsubishi cars, and even honda b series cars. |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|