cup holders!!!

[aluke000]

Used $10 shipped from an early 90's Sentra. Probably 5 bucks from your local junk yard. Standard part, so they should be easy to get. If you don't happen to have a 1/2 DIN audio component, you can probably get a 1/2 DIN blank from an older Z car or any audio shop that will fill the same spot.

Install is easy, just need two 1" nylon spacers from the local hardware store and longer screws.



And that's a Henry Weinhard's Private Reserve Hefeweizen for my poor sick granny :frog: (just kidding, granny prefers gin)

[stoneage_tech]

i posted this some where else on here too so herte goes....there is a cup holder in a early 90s passat that bolts into the side of the center console it is VW part number 3A1-862-531-01C OR 3A1-862-531-O1C The parts guy hand wrote my part number so i cannot tell if it is a 0 or a o it will cost 36.80 here in alaska so if anyone else can get it cheaper in the lower 48 let me know

I like to drink and drive
Mike

[pearl-p10]

I looked everywhere for one of those dam cup holders. Every Sentra and NX2000's that I found at the junk yards were completly molested. I did find the passat cup holder but am having second thoughts about the whole bolting process. If it looks stupid I don't want holes in my car if I decide to remove it. If anyone has the passat cup holder installed, will you please post pics? thx

[aluke000]

Geez if I knew the Sentra cup holder was going to be soughtafter, I would have gotten more than one. The guy had three when I bought mine. Heck I paid more for shipping than I did for the unit itself...

[Blue94G20T]

Lucky for me I still had some stuff from my old SER and found a cup holder. Is this the same one you installed ALUKE?

[Blue94G20T]

Originally posted by Blue94G20T
Lucky for me I still had some stuff from my old SER and found a cup holder. Is this the same one you installed ALUKE?

[Blue94G20T]

More..

[Blue94G20T]

Originally posted by aluke000
Here's a pic with the cup holder pulled out. A metal bracket pops down below to hold the cup/cans up and there are two metal thingies that can flip up or down for thinner sized cans (Red Bull sized cans)

Here is another pix of the metal thingies

[Blue94G20T]

Here is a picture of the cup holder shut

[aluke000]

That looks like it all right. Get yourself a 1/2 DIN blank or pocket and some spacers and you are good to go.

[Blue94G20T]

Originally posted by aluke000
That looks like it all right. Get yourself a 1/2 DIN blank or pocket and some spacers and you are good to go.

Great. Thanks!