|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Forced Induction Discuss topics relating to turbochargers, superchargers, and nitrous oxide systems. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-05-2003, 02:40 PM
|
||||
|
||||
|
2001 b18b+turbo
2001 b18b+turbo
what do u guys think a 2001 integra ls with a drag 3 turbo set up would run? besides the turbo, i want to run a fuel pressure regulator, cat-back exhaust and street tires. this is all going to be on 8psi. could anyone guess the 1/4 E.T.? sorry, i already posted this in the integra forum, i just need more input. also what about peak horsepower with this setup and what about dyno charts?
__________________
Co-Founder of AF V-Card Club 1999 Ford Mustang Cobra: Cobra R rims, Magnaflow CB. "no way man...i saw an LS1 fight godzilla and the LS1 beat godzilla and it looked in the air and was like what do you think of that god and god was like bring it bitch so they fought and the LS1 beat god now the LS1 is god because its the greatest thing ever." 
|
|
#2
04-05-2003, 05:39 PM
|
|||
|
|||
|
peak hp would probably be around 230. that is on stock internals and 8 psi. your et would be about mid 13's but im not exactly sure so someone else could chime in here but im pretty positive you will not be in the 12's
__________________
I feel bad for those who pay twice as much as i did for my car and still lose to me. The sorrow in their face is enough to bring me to tears.
|
|
#3
04-07-2003, 02:32 AM
|
||||
|
||||
|
i'm sorry but i disagree with you an ls engine - while is a good engine to turbo won't run in the mid 13 with only 8 psi. maybe with a new race head but definitevelly not with the stock head.
also as power is concerned i would say lower than 230 to the wheels maybe 230 to the crank. i'll chose to be more conservative and say ~190 to the wheels. also IMO your 1/4 mile will be low 14's.
__________________
 (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination
|
|
#4
04-07-2003, 04:03 AM
|
|||
|
|||
|
hey go to overboost.com if you click on forced induction they have a integra LS that they put the drag gen 3 kit on. shows instructions on the install. this is what they had to say.
"As you can see from the dyno readout, the newly turbocharged non-VTEC Integra is putting out a very healthy 257 horsepower @ 6500 rpm to the wheels! Not to mention over 216 ft-lbs. of torque! T his was good enough to make a 13.28 @ 104.9 mph pass on the ¼ at the April All Import Challenge in Pomona… on a stock clutch!" results will vary but this kicks my friends turbo GS-R with the same kit. he runs 13.8 with shitty clutch. good luck!
|
|
#6
04-07-2003, 04:55 AM
|
|||
|
|||
|
they say 6-7 pounds, thats what the wastegate is set to when you get it. these are prob really good results out of this engine. my friends GS-R with the same kit ran 13.8 with a shot clutch. Ive heard the LS with this kit is right up there and these results show it.
|
|
#7
04-07-2003, 07:19 PM
|
|||
|
|||
|
wow i was a lot closer then i thought. damn im good!
 jk
__________________
I feel bad for those who pay twice as much as i did for my car and still lose to me. The sorrow in their face is enough to bring me to tears.
|
|
#8
05-02-2003, 01:24 PM
|
|||
|
|||
|
i'd say mid- 13's... but you could build the engine and run 15lbs and just run low 12's high 11's.
__________________
my girlfriend calls me a car nut like its a bad thing
|
| ||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
