|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Exterior | bodykits | Lighting When your ready to showoff that 'H' ride, here's your forum! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
02-28-2003, 03:59 PM
|
|||
|
|||
2001 Civic Si bumper cover removal
Any one know how to remove the rear bumper cover? I'm not sure how it's attached....ie where all screws are , if attached to rebar etc..
ANY help would be appreciated. Thanks for the space.... 
|
|
#2
02-28-2003, 04:19 PM
|
|||
|
|||
|
I've got a 98 civic with a Black Widow back on, but it's probably not too different removing your bumper. Look for a screw at each side near the wheel well and then there's some clip thingies in the trunk area that pop out with a flathead screw driver. That's all there is to secure my back bumper. Hope this helps.
|
|
#3
03-03-2003, 11:54 AM
|
|||
|
|||
|
Do you live in Canada? They didnt make a 2001 Civic Si....
|
|
#4
03-03-2003, 12:27 PM
|
|||
|
|||
|
Ok....Brandon then it is a 2002..its not my car.
Anyways....Thanks for everyones help. To remove the bumper: - Remove screws from under the wheel well ...on each side. - Open trunk and you should see two black plastic plugs on the bumper cover (remove with flat screw driver) - Remove the two 10mm screws - Look underneath the bumper there will be two more black plugs (remove them) - Now gently pull the bumper off...it should snap off...its only holding on by clips. Whole thing shouldn't take you more than 10 min.
|
|
#5
03-05-2003, 05:45 PM
|
|||
|
|||
|
I was just asking because if it was a 2000 I could tell you how...
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
