question about sparco torinos

[casperGSR]

I posted this question in the integra forum but didn't get any feedback so I'm hoping I'll have better luck here... I just bought a pair of sparco torinos for my car ('00 integra gsr) and tried installing them this weekend but ran into some problems... I was able to bolt in the rear two bolts but when I went to do the front two the sparco brackets not only lined up to the right of the holes from where the stock seats were but was also about an inch further away (meaning that the sparco brackets are longer in length then the stock ones)... Aside from bringing my car to a shop to have it done (which I'm almost at the point of doing) does anyone have any suggestions as to what I could try doing to fix the problem. Thanx in advance for any ideas.

[Gusto222]

dunno what to tell u man.. try another Forum site.. liek honda-acura.net - or acuraclub.com

[kicker1_solo]

Originally posted by Gusto222
dunno what to tell u man.. try another Forum site.. liek honda-acura.net - or acuraclub.com

if you don't know, don't post.