|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
07-07-2023, 02:58 PM
|
|||
|
|||
|
Need help
Trying to find the hydraulic line from master to slave in a 1996 pontiac grand am gt 2.4l 5 speed manual trans..
Been looking for 2 weeks now if anyone has had the same problem or can help in anyway it would be greatly appreciated thanks 
|
|
#2
07-07-2023, 03:21 PM
|
|||
|
|||
|
Re: Need help
__________________
Post back, that's what makes Forums Work.
|
|
#5
07-08-2023, 09:21 AM
|
||||
|
||||
|
Re: Need help
That's likely going to an "OEM only" part.
Your other option is to take the existing line and fittings to OReilly's/Advance/Auto Zone/NAPA, and see if you can match it up. I'm assuming it's a hard line so it's going to be similar to any brake line. The hard part will be getting it all bent in and out of the way.
__________________
|
|
#6
06-24-2026, 08:34 PM
|
|||
|
|||
|
Re: Need help pontiac grand am 1995 3.1
Hi! I live in Brazil and own a 1995 Pontiac Grand Am with a 3.1L V6 engine. It won't stay running; it cranks and fires up for a second if I give it a little gas, but then it dies. I've been looking for a scanner but can't find one anywhere. I built a cable using a USB board, a chip, a 10k-ohm resistor, and a diode. I'm trying to download TunerPro, but the site is blocked in Brazil... Does anyone know if this program will read my car's system? Can I use this program with the specific engine file? The software needs that file to load the settings for the 3.1L V6 engine... Can anyone help me? Thanks!
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
