Hi, I’m hoping that this is an easily answered question from those more mechanically savvy than I. I have an 06 Chevrolet 1500 Express standard van The photo is of two brake lines running to the front left drivers side. I’m not familiar with this setup, so to say, as far as the White blocks and different overall appearance with the braided type connecting lines. Is there a reason why they aren’t just standard lines all the way through? One is leaking,and I wasn’t sure if it required anything special to replace them? Can I have those sections cut out and have standard lines coupled on the ends for now? Any info, suggestions or advice is greatly appreciated! I have other photographs if need.
I found a short, older video on, of course, YouTube, and it shows that this is the factory setup. Apparently, the braided lines were used to prevent them from rubbing against a single brake line which runs under them. It didn't' seem to work out and there were full brake failures, but from the single hard line apparently. My issue is replacing the braided lines, which are what is leaking.
08-27-2023, 09:02 PM
