|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#136
11-08-2018, 05:54 PM
|
||||
|
||||
|
Re: LHD Seven
Today's project was to make this Mallory HyFire6 ignition box in SolidWorks.
  
|
|
#137
11-09-2018, 01:24 PM
|
||||
|
||||
|
Re: LHD Seven
I added the side terminals to the top and notched the rib in the main body to match.
|
|
#138
11-09-2018, 04:13 PM
|
||||
|
||||
|
Re: LHD Seven
I finally got around to bolting the starter onto the engine. Just needed to make the hardware…
|
|
#139
11-09-2018, 08:47 PM
|
||||
|
||||
|
Re: LHD Seven
The master cylinder is done. The cap was machined as were the fittings and mounting hardware. The seals between the reservoir and cylinder were made from soft vinyl. The decals were drawn and printed by me.
|
|
#140
11-10-2018, 01:41 PM
|
||||
|
||||
|
Re: LHD Seven
The header had already been modified to work with the other LHD converted pieces from when I wrote the Scale Auto article chronicling how to do it.
It was in two pieces still as it comes in the kit. I cemented them together and filled the seam and ejection pin holes. The flanges have been drilled to accept the mounting hardware (that I still have to make). 
|
|
#141
11-10-2018, 02:54 PM
|
||||
|
||||
|
Re: LHD Seven
Side terminal connectors for the battery made from brass.
|
|
#142
11-12-2018, 04:21 PM
|
||||
|
||||
|
Re: LHD Seven
Heat shield for the muffler rough cut from brass and reinforced with aluminum rings.
|
|
#144
11-12-2018, 06:46 PM
|
||||
|
||||
|
Re: LHD Seven
Machined it by hand on my mill.
|
|
#146
11-12-2018, 08:24 PM
|
||||
|
||||
|
Re: LHD Seven
Thanks!
The muffler was machined and etched with the logo. 
|
|
#147
11-13-2018, 11:56 AM
|
||||
|
||||
|
Re: LHD Seven
The pipes were bent from brass tubing. The rear bracket is brass sheet.
|
|
#148
11-13-2018, 04:47 PM
|
||||
|
||||
|
Re: LHD Seven
I milled flanges to attach the exhaust system to the header.
|
|
#149
11-13-2018, 08:30 PM
|
||||
|
||||
|
Re: LHD Seven
I finished making the battery cables for the side terminals. (The hex heads are the correct size.)
|
|
#150
11-14-2018, 11:27 AM
|
||||
|
||||
|
Re: LHD Seven
The battery is done, slightly weathered/dirtied up. (I can't attach the cables until I know how to route them after I install it.) The top terminals are scaled correctly so the positive one is a hair larger diameter than the negative post. I drew all the art and printed the decals.
   
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
