-
Grand Future Air Dried Beef Dog Food

Carnivore Diet for Dogs

Air Dried Dog Food | Real Beef
Go Back   Automotive Forums Car Chat > Chevrolet > Avalanche | C&K | Silverado | Suburban | Tahoe > Suburban
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 09-02-2015, 10:13 AM
Hyde0406 Hyde0406 is offline
AF Newbie
 
Join Date: Jul 2015
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
HELP!!! 2003 Sub. LOST NEED HELP

Ok everyone I need some help.
I have a 2003 suburban and as the truck sits could be overnight could be 20mins its dead. It is a hit and miss when it happens. I had in the shop they looked for a drain, NO DRAIN, I have replaced the Alternator, Starter & battery..

Still no luck went out to start it in the morning and it barely started. I had the Alternator tested all is good, I went and bought another battery last night. The positive terminal was getting hot. And now barely starts, I am open for help.

Thanks
Reply With Quote
  #2  
Old 09-02-2015, 01:22 PM
gmtech1's Avatar
gmtech1 gmtech1 is offline
AF Enthusiast
 
Join Date: Aug 2011
Posts: 2,001
Thanks: 4
Thanked 303 Times in 301 Posts
Re: HELP!!! 2003 Sub. LOST NEED HELP

Be sure the battery cables are clean and tight on both ends of each cable, I would also check voltage drop on each cable when cranking. If voltage drop is more that 200 mV, replace the cable(s).
Reply With Quote
  #3  
Old 09-02-2015, 01:47 PM
j cAT j cAT is offline
AF Fanatic
 
Join Date: Oct 2007
Posts: 10,898
Thanks: 8
Thanked 432 Times in 431 Posts
Re: HELP!!! 2003 Sub. LOST NEED HELP

the battery connection is hot !!!!! could be also some other connection issue like what you have stated .. this means that cable lug connection is defective.. the heat is the resistance creating a hot spot.. this means low amps into OR out of the battery. I would first try to clean the connection .. ALSO if those connections or the wiring is GREEN replace this battery wire connector .. these are available at the auto stores and you may need to solder in the new wire connector into the existing OEM wire. this then you will need some solder a small torch and some heat shrink wire covering so as to prevent any exposure to the elements..
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Chevrolet > Avalanche | C&K | Silverado | Suburban | Tahoe > Suburban


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 05:12 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts