2001 T&C overhead garage door button

[SRC1968]

Hello,

My engine blew, and so i replaced with a used engine. I was wondering if that would make my overhead garage door button not work. if so, is there anything i can do to get that to work?
thx

[aleekat]

Figuring that you had your battery disconnected during the engine swap, reprogram the button.

[SRC1968]

i have tired. it isn't excepting code. I have tried that 4 differ. times... and including disconnecting battery and reconnecting it to see if that would help. Could this be because of the different engine, but didn't change the computer?

[SRC1968]

Originally Posted by aleekat

Figuring that you had your battery disconnected during the engine swap, reprogram the button.

i appoligize. I went out and googled the directions... step by step.... and even though i did this... it wasn't working... but i must have been missing a step because after 40 min. last night of trying it over and over...
all of a sudden it worked. Maybe have a short or somethign.. i don't know.
but i got the dumb thing to work... yeah..
thx

[aleekat]

The last one I did, I had to hold the opener right up against it before the code would get captured.

[Cntrysthbst]

can you clear all the homelink programs and start over? think you have to hold first and third position for a minute, it will say erased, and then can try to reprogram. i ran into this problem when the transmission was replaced.