 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
05-28-2008, 01:59 AM
|
#1 | |
|
AF Newbie
Join Date: May 2008
Location: edmonds, Washington
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
|
I am looking to replace the floor on 24' Moving Truck
Floor needs to be replaced on my Moving Truck
Currently plywood floor 6 4'x8' sheets Was looking to use 3/4" t&G, with a sealant underneath, and some type of sealant on top. any other recommendations |
|
|
|
|
06-25-2008, 02:54 PM
|
#2 | |
|
AF Newbie
Join Date: Jun 2008
Location: Beverly Hills, California
Posts: 6
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: I am looking to replace the floor on 24' Moving Truck
good materials here www.f150aftermarket.com
|
|
|
|
|
|
07-19-2012, 11:14 AM
|
#3 | |
|
AF Newbie
Join Date: Mar 2012
Location: Niagara Falls, New York
Posts: 63
Thanks: 0
Thanked 1 Time in 1 Post
|
Re: I am looking to replace the floor on 24' Moving Truck
i have built a couple trailers here and there at home. and i find that a solid sheet of metal works great. you can get a 1/4 inch piece fairly cheap and never have to worry about rotting wood etc. If you use multiple sheets of metal you can get a flat weld done so its smooth. Only thing is thats its a little slippery when wet. But there is a material that you can spray on that seals and gives a little texture for grip. If you have a ramp and not a lift gate on the back i find welding a thin metal mesh to the ramp is great for grip walking up and down.
-Jsaw |
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
