|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Problem Diagnosis Got a problem you can't fix? Post here and one of our members will answer as soon as possible. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#16
12-21-2010, 04:47 PM
|
||||
|
||||
|
Re: Won't Start
Got my fingers crossed, post your results.
__________________
You have to know how it works, to figure out why it doesn't. 
|
|
#17
12-25-2010, 07:37 PM
|
|||
|
|||
|
Re: Won't Start
Going to put the cap and rotor on tomorrow. Waiting still for the fuel pressure gauge. Should I put the Dielectric grease on the rotor metal contacts, and center carbon piece inside the cap as well? Thanks.
|
|
#18
12-25-2010, 08:25 PM
|
|||
|
|||
|
Re: Won't Start
yes. dielectric grease on all contact points inside and out!
__________________
2001 Chevy Blazer 4.3L 5 speed manual Alpine deck, Type R 12in. sub. 145k miles 1997 Pontiac Sunfire 2.2L automatic trans 146k miles
|
|
#19
12-26-2010, 10:49 PM
|
|||
|
|||
|
Re: Won't Start
Well..............installed the cap and rotor today. TWO WORDS: SHE WORKS!!!!!!!!!!!!!!!!!!
I can't believe that was the problem! Had symptoms of a ignition switch....which was replaced as well, but so what. They had issues anyways. Thank you for your help!
|
|
#20
12-27-2010, 10:06 AM
|
|||
|
|||
|
Re: Won't Start
Question? Did it throw a code?? Check engine light on? had this same sort of issue with my 01 jimmy 4.3L. After hours of trouble shooting and checking voltages and grounds it turned out to be the Crank Position Sensor. located on front bottom of motor right behind Harmonic balancer on Passenger side. i replaced that and it still had the same problem. Trouble shot some-more Wiring and Grounds and it turned out that the new Crank Position Sensor was not seated all the way into block.
Just something to think about.
|
|
#21
12-27-2010, 10:50 AM
|
|||
|
|||
|
Re: Won't Start
Never got a chance to pull any codes. Had to have it towed home. ABS light would flash on just before it died. No engine service light was on.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
