![]() |
![]() |
Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
![]() | ![]() | ||
![]() | ![]() |
| Latest | 0 Rplys |
|
![]() |
![]() ![]() ![]() |
|
Thread Tools |
![]() |
#1 | |
AF Newbie
Join Date: May 2010
Location: Vladimir
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
![]()
Hello everyone, I have a machine Buick Regal Limited 3.1 1991
The problem can not make. Checked injectors, ignition module, coil, wires, candles - all ok! The verification module plugs for the presence of signals from the crankshaft position sensor is, the light bulb connected to the ignition module connectors flickers - do conclusion crankshaft sensor works. In light jets also flickers - a conclusion the brain works. Gasoline pump keeps the pressure regulator of fuel on the ramp - works, return line is not clogged. What else to check how to check the label on the motor without disassembling it. |
|
![]() |
![]() |
![]() |
#2 | |
AF Moderator
![]() Join Date: Jan 2005
Location: El Paso, Texas
Posts: 18,017
Thanks: 30
Thanked 54 Times in 42 Posts
|
Re: Hello everyone, I have a machine Buick Regal Limited 3.1 1991
Welcome to AF.
What driveability issues are you having? Hard to tell by your post.
__________________
'08 Pontiac Grand Prix GXP (Dark Slate Metallic) - LS4 5.3L V8 '02 Oldsmobile Alero GL2 - LA1 3400 V6 '99 Buick Regal LS - L36 Series II 3800 V6 '03 Honda CR250R MX - 2 Stroke 250cc '97 Pontiac Grand Prix GTP - L67 Series II 3800 V6 Supercharged (Sold) Timeslip 08/12/06 AF Community Guidelines |
|
![]() |
![]() |
![]() |
#3 | |
AF Newbie
Thread starter
Join Date: May 2010
Location: Vladimir
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Hello everyone, I have a machine Buick Regal Limited 3.1 1991
I live in Russia and it's difficult with the language, I use a translator, found the problem!
Sam doing a car, but mostly domestic and German. Though most Americans, that's why went to your sites. Many questions very much! If no trouble can explain everything? |
|
![]() |
![]() |
![]() |
#4 | |
AF Newbie
Thread starter
Join Date: May 2010
Location: Vladimir
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Hello everyone, I have a machine Buick Regal Limited 3.1 1991
What do the error code 23 and 35 can not find?
|
|
![]() |
![]() |
![]() |
#5 | |
stupidity should hurt
![]() Join Date: Aug 2004
Location: Flint, Michigan
Posts: 10,129
Thanks: 2
Thanked 22 Times in 22 Posts
|
Re: Hello everyone, I have a machine Buick Regal Limited 3.1 1991
code 23 Manifold air temperature sensor signal showed an air temperature of -31� F for 10 seconds after engine had been running for 4 minutes
**this would normally indicate a bad sensor.** code 35 Engine idle speed is either 300 RPM above or below the desired idle speed for 50 seconds **this could be caused by many issues (a vacuum leak, bad IAC valve, etc...) so more diagnosis would be necessary.
__________________
![]() Still waiting for the "good old days" I'll get to bore my future grandchildren with! |
|
![]() |
![]() |
![]() |
#6 | |
AF Newbie
Thread starter
Join Date: May 2010
Location: Vladimir
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Hello everyone, I have a machine Buick Regal Limited 3.1 1991
From the 23 figured out, I have not hooked.
35 sucking air in kolletor or МАР sensor? Would you drive any better with that cell phone up your ...?!-----not understand |
|
![]() |
![]() |
![]() |
#7 | |
AF Newbie
Thread starter
Join Date: May 2010
Location: Vladimir
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: Hello everyone, I have a machine Buick Regal Limited 3.1 1991
right there all
from motorcycles to trucks well then the weather |
|
![]() |
![]() |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|