1g head stud torque sequence?

[sganc4life_4]

Anyone have the torque sequence? Im removing the head and need it.

[sganc4life_4]

Nm, found a diagram.

[SilvrEclipse]

Can you post it up here for future reference?

[sganc4life_4]

Dsmtuners recommends a few things:

Torque in steps, ie 30-60-90 ftlbs instead of each to 90 to prevent warping.

They also have a shit ton of info about torque amounts starting from page 9 until the end here.
http://www.dsmtuners.com/forums/newb...cations-9.html

I recommend a read through the entire article, lots to learn.

[kjewer1]

Make the last step the biggest. If it's too small the torque wrench will just click without the nut turning (overcoming the initial starting friction). If this happens back them off and start over.

I captured some more info and lessons learned the hard way here, http://www.posracing.net/ARPstuds.html