|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Cutlass Series Includes Cutlass Ciera, Cutlass Cruiser, Cutlass Calais, Cutlass Supreme, Custom Cruiser, as well as the GM N-Body subforums. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
10-04-2009, 04:38 PM
|
|||
|
|||
|
Radiator/Coolant Issue
Hello,
New to the forum...I have a 1992 Cutlass Supreme, 3.1 engine. Recently the heater hose broke (corroded). I purchased a new hose and installed without any problems. Followed mdirections from car manual to fill/replace coolant....heater works for a while then it gets cold...engine overheats....wating for a while for engine to cool, repeat process but still same results. What am I doing wrong? Is the a specific way to replace the coolant? Regards, Ric. 
|
|
#3
10-05-2009, 08:06 PM
|
|||
|
|||
|
Re: Radiator/Coolant Issue
Hmm...no, I have never run into something laike this...What is the required procedure for bledding the cooling system? Could anyone inform me?
Thanks in advance....
|
|
#4
10-06-2009, 08:33 AM
|
|||
|
|||
|
Re: Radiator/Coolant Issue
There are 2 bleeder screws one near the thermostat housing and one on the coolant pipe I believe ,you get the engine warmed up open these and wait till coolant flows in a nice stream to bleed the air, you could do a google or site search for the procedure also.
__________________
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
