Front right wheel heating up

[yahoo1]

Hi guys! I haven't posted in a long time. Problem: The front right (passenger) wheel heats up after my 2002 Escort SE is driven for a long time in hot weather. The other 3 wheels are fine. It takes maybe an hour or two at 55mph before this happens. The only clue I have, is that when this happens I can hear something rubbing when I just barely touch the brake pedal (when the wheel has heated up). It's hard to check the problem out, because I almost never drive the car for over about a half hour from home. However I did take a 200 mile trip this past weekend, and I checked the wheel once after a couple of hours, and it definately was too warm (or hot). I took it to a garage today, and they didn't find anything wrong with it. (I don't know exactly what they did to check it). Oh, the tire is NOT underinflated, and the car does NOT pull or drift to the right. In fact, it tends to drift slightly to the left. Could anyone give me some suggestions what might be causing this heating problem?
Thanks much, guys!
yahoo1

[yahoo1]

I forgot to mention that I DIDN'T smell anything burning, even tho' I had to drive for a couple of hours with a warm (or hot) wheel.
Thanks again.

[AzTumbleweed]

Sounds like a brake is dragging a little.

[yahoo1]

Thanks for your post, Tumbleweed! Can I get any other possibilities?
yahoo1

[AzTumbleweed]

Next time it warms up feel the rotor.

[yahoo1]

Originally Posted by AzTumbleweed

Next time it warms up feel the rotor.

My health won't permit me to climb under the car Tumbleweed (I'm 76), and even if I could I'm not sure that I'd know which part the rotor is. (I do know that it's part of the front brakes.)
Thanks for posting!!!

[Davescort97]

Could be master cylinder piston not returning correctly or a restricted brake line or hose on the RF wheel. It shouldn't make any noise when lightly braking. I suspect the caliper is sticking and should be lubricated with a high temerature lubricant for brakes.
If you haven't had brakes for 50k or more now would be a good time to replace the pads and turn the rotors.

[TheBobsHere]

Here's my take on the problem. Brake fluid is hygroscopic (absorbs moisture from the air) and the combo of water and brake fluid in the system causes brake lines to rust and hoses to rot/swell from the inside out, once this starts to happen it's common for the engine heat to cause an already swollen brake hose to swell shut after everything gets up to temp, trapping fluid which (since there is water in the mix and since water expands with heat) causes the caliper to expand thus causing drag. Since in the early to mid-stages this particular problem needs heat soak to soften the hose and to cause the water present in the brake fluid to expand for it to swell shut, it's a hard to diagnose problem (until it swells completely shut causing severe brake drag and possible wheel bearing damage, that is). When things go past this point you can get little pieces of rubber that break off of the rubber brake hoses or rust from the steel lines throughout the brake system and may need a complete brake job with calipers/hoses and sometimes even steel lines and master cylinder needing to be replaced. What am I getting at, you ask? Replace the brake hose and flush the system. If that remedies the problem, replace the rest because they aren't far behind.
Also, NEVER touch any brake rotors (big shiny round thing) or drums after the car has been driven until they have a chance to fully cool. Those things get very very hot and will remove fingerprints for life.

[Davescort97]

Welcome to AF!

You are right about the brake fluid getting moisture into it. A few years ago I had a Honda with a hydraulic clutch. One winter it got so cold the moisture in the fluid froze up and I had to bleed the clutch and put new brake fluid in the system. Thanks for the information. It will go into archives until someone researches it. You know your way around cars, and I hope you post again, soon.

[yahoo1]

Thank you very, very much Bob, Dave, and Tumbleweed for your suggestions! It just might turn out that one of them will be the solution to this annoying problem. Best wishes to all of you.
yahoo1

[FordMan59]

One other thing that will cause the wheel to get hot besides the brakes not releasing is a bad or dry wheel bearing. I've actually seen a dry wheel bearing make it so hot it would smoke. If a mechanic checked it out he should have checked the wheel bearings. I'd ask.

[yahoo1]

Originally Posted by FordMan59

One other thing that will cause the wheel to get hot besides the brakes not releasing is a bad or dry wheel bearing. I've actually seen a dry wheel bearing make it so hot it would smoke. If a mechanic checked it out he should have checked the wheel bearings. I'd ask.

Thanks Fordman!!!! Much obliged!
regards,
yahoo1

[FordMan59]

Just wondering if you had found out what the problem was yet or not. Please keep us informed.

[yahoo1]

Originally Posted by FordMan59

Just wondering if you had found out what the problem was yet or not. Please keep us informed.

Hi Fordman! Well, here's the "scoop"--- I just spent $319.68 (including 8% tax), about two hours ago on the brakes. For that I got two (2) Calipers and brake pads. The bill's out in the car so I don't know what else they installed, if anything. The garage owner told me that the rt. front caliper was BLUE, so he claims that I was right about the wheel over-heating. You might find it interesting that he suggested that I spend over $600, but I "nixed" that idea. He wanted to install brake hoses, and also new rotors, I think, for the $600 plus amount. So anyway, I haven't had a chance to drive the car very far yet, to see if it's OK now. We'll know more later. I did ask the garage owner if the brakes will work ok if I take a 200 mile trip today, and he said absolutely. I sure hope the guy knows what he's talking about. Oh, one more thing---I noticed that the brake pedal is a bit lower than it used to be, but the brakes seem to stop fine.

[FordMan59]

Sounds good hope it took care of your problem.