tranny p1762

[ldrroch]

trans wont shift and when is shifting has no pick up also briging up code p0138

[99 Neon R/T]

well the only tranny code i could find like that was p 0762 which is shift solenoid circut c stuck on.p0138 is o2 sensor circut high volts bank 1 sensor 2.The wiring harness for the tranny runs down the driver side inside of the frame rail along with the o2 sensorwiring.That may be a good place to start troubleshooting.Check for loose or broken wires.If not you may have a bad valve body and o2 sensor.Good luck I hope it is a quick fix for you

[xj31]

p1762=governor pressure sensor offset volts too low or too high

[srjeeper]

Originally Posted by xj31

p1762=governor pressure sensor offset volts too low or too high

Anyone know how to fix this problem.I have this code coming up on my 02 Dakota.It pulls away in third gear most of the time,but sometimes it sticks in first gear.


EDIT: I've done some searching and reading and figured out that,when it stays in third gear this is a safe mode.Now I figure I have to change the governor pressure sensor and transducer.I can do the job myself I just don't have any info on where the parts are.My question now is where are they on or in the tranny?

[troy1]

First off what engine to you have? 4.7L will be different.

***3.9L, 5.2L & 5.9L only***
Buy the new parts and pull the pan pull four 7/16 bolts and two T25 torx bolts to remove the solenoid aluminum block and remove the two items and replace. Don't over tighten the T25 torx hand tight with a screw driver is all they need.

[srjeeper]

Yeah sorry I didn't specify the motor details,it's a 2002,2wd, 3.9L.

Thanks in advance.

[troy1]

Ok this will work with the 3.9L also

[srjeeper]

Sounds easy enough,Thanks again.