|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#3
10-07-2007, 01:58 PM
|
||||
|
||||
|
Re: Ignition Switch
ignition switch or key cylinder?
__________________
Being way2old is why I need help from younger minds The sooner you fall behind the more time you'll have to catch up.  HEY Y'ALL--READ THIS Here are some of our old vehicles for sale. 
|
|
#5
10-07-2007, 04:34 PM
|
||||
|
||||
|
Re: Ignition Switch
If the entire cylinder has come out, use a screwdriver and stick it in the slot. Twist it until the dash lights come on. Hold new cylinder and turn the key to on position. Line up cylinder with grooves and install. When it bottoms out, turn the key off and remove. This will allow the locking poin to come out and lock the cylinder in place.
__________________
Being way2old is why I need help from younger minds The sooner you fall behind the more time you'll have to catch up. HEY Y'ALL--READ THIS Here are some of our old vehicles for sale.
|
|
#6
10-07-2007, 04:46 PM
|
|||
|
|||
|
Re: Ignition Switch
if you are replacing key/tumblers.your neighbor drilled what??where you put
the key in??if so,pull steering wheel(no air bag right?)unbolt horn & turn signal sw.& move it out of way.remove lock pin/screw & pull out key/tumbler. you have to remove turn sig. sw. & tilt levers disconnect battery before you start Good Luck!!
|
|
#7
10-07-2007, 06:37 PM
|
||||
|
||||
|
Re: Ignition Switch
Go to this site. It has instructions on how to install.
__________________
Being way2old is why I need help from younger minds The sooner you fall behind the more time you'll have to catch up. HEY Y'ALL--READ THIS Here are some of our old vehicles for sale.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
