|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
09-22-2007, 07:45 PM
|
|||
|
|||
|
2007 instrument panel
My instrument panel went completely dead today after pulling a rental trailer. Also the blinkers and stop lights. I can't seem to find the bad fuse. Would this be the self resetting fuses refered to in the manual, serviceable only by a dealer? thanks
|
|
#2
09-23-2007, 12:40 PM
|
|||
|
|||
|
Re: 2007 instrument panel
Did this trailer just have a plug you hooked up to or did you or someone have to experiment around hooking wires up to make the trailer lights work?
__________________
Retired USAF/ Nuclear Plant Controls Dude Had Recently 1996 Caravan 3.0 Great Car 2005 Impala 3.8 Now 2000 GC 125K 3.3 2006 T&C 3.8
|
|
#3
09-24-2007, 06:06 PM
|
|||
|
|||
|
Re: 2007 instrument panel
Just plugged it into the flat plug, I have emailed chrysler and haven't got a response yet. All the trailer lights worked fine when I left the rental place. I did drive about 5 miles on a rough dirt road. thanks
|
|
#4
09-24-2007, 09:10 PM
|
|||
|
|||
|
Re: 2007 instrument panel
I assume it is still under warranty. If so I would let the dealer sort it out. If not under warranty, I would start by turning the ignition and everything else off, then disconnect the battery neg. terminal for a few minutes. Then hook it back up. See if there is improvement.
Just curious, was everything off when you disconnected the trailer like ignition, lights?
__________________
Retired USAF/ Nuclear Plant Controls Dude Had Recently 1996 Caravan 3.0 Great Car 2005 Impala 3.8 Now 2000 GC 125K 3.3 2006 T&C 3.8
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
