|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
07-14-2006, 09:02 AM
|
|||
|
|||
|
'98 ZX2 - Tension Release for Alternator
What's the easiest way to release the belt tension when re-installing an alternator on a 98 ZX2? Every alternator I've ever replaced has always had a bolt that the alternator itself swivelled on to release and tighten the tension. This one doesn't
|
|
#2
07-14-2006, 02:45 PM
|
||||
|
||||
|
Re: '98 ZX2 - Tension Release for Alternator
the tensioner, put a 1/2 inch wrench on it and pull back (towars the rear of the car) andit will releive belt tension. it's next to the water pump.
__________________
-Josh- 96' Integra GSR / ITR cams/valvetrain. Skunk2 IM, Greddy evo2, AEM CAI, RMF Header, Megan testpipe, Hasport mounts, Eibach coilovers, Beaks tie bar, Megan H brace, Rota Attacks, F/R strut bar, Kirk 6 point cage, Bride Cugas, Takata 4 Point, ITR Steering wheel 98' SVT Contour, 3L Port-Matched swap with SVT cams/full bolt ons; 224fwhp. 01' Chevy Blazer, DD.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
