|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Performance Discuss Engine, Suspension, Drivetrain, and all other performance modifications here. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-11-2007, 09:23 PM
|
|||
|
|||
|
Where did you mount your MSD?
I currently have my MSD mounted above the distributor. However I am finding it getting to hot in that location. I have already had to replace one due to heat, and I live in Calgary, not the warmest climate city.
Where are some of the locations you have mounted yours? 
|
|
#2
08-12-2007, 11:11 PM
|
||||
|
||||
|
Re: Where did you mount your MSD?
another place to put it under the hood where it would still be accessable is on top of the blower motor housing.
__________________
2000 Chevy Blazer ZR2 Performance Mods: Numerous Suspension Mods: Some, but not enough Exterior Mods: Just Right 1987 Buick Turbo T Dark Red Low 11 sec sleeper  .030 4.1 block, PT6262E, & other odds and ends.... My Cardomain
|
|
#3
09-19-2007, 07:39 PM
|
|||
|
|||
|
Re: Where did you mount your MSD?
I placed mine inside of the center console between the seats. I put a vent above and below it. I mounted it vertical. And left enough room so that I can do any adjustments by removing the top vent. You would have to take out the center console . And mount it to the metal support. It will also act as a heat sink. there is enough room between the support and the plastic for it to fit there. You can pull out the bin and still not see it there. I forgot to mention that it is a Crane IS6, But they have about the same dimensions.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
