|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
![]() |
Show Printable Version |
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
|
|||
|
|||
|
accessing rear door handle in 2000 lesabre
am needing information in how to remove door handle from the rear door of a 2000 lesabre....after the door panel is off of course.
thanks in advance |
|
#2
|
|||
|
|||
|
Re: accessing rear door handle in 2000 lesabre
I replaced the front door lock actuator on my '99. I had to take out the whole internal workings.. -- lock actuator, window actuator, door handle- everything. it all came out.. It is a 1999, here are my notes, for what its worth. A 2000 may be similar.
Take off inner door panel Un hook all cable hold downs in metal inner panel Remove 5 Torx and take off speaker Lower window to about half and remove 2 nuts attaching window to lifter base channel From inside push window up and tape in closed position Remove 4 torx screws from end of door Take off all nuts holding inner panel to door Use on extension to go through inner door holes and remove 2 10mm bolts to door handle Slide c clip off back of key lock On outside of door pull door handle rod up and unclip plastic clip and slide handle off rod On outside of door pull key lock rod up and unclip plastic clip and slide key off rod Remove inner panel with rods and actuator/door latch
__________________
Daily Driver: 2008 Chevy Impala - 30000 mi Others:1993 Chevy S10 - 85000 mi, 2000 Saturn SL2, 1987 Buick Lesabre RIP, 1999 Buick Lesabre |
|
#3
|
|||
|
|||
|
Re: accessing rear door handle in 2000 lesabre
Thanks rustbucket for your reply......will print this off and hopefully when time permits we can get this repaired ourselves. Thanks again!!!
sivad
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|