|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
||||
|
||||
|
No acceleration
I have a 93' that seems to have retired it's racing shoes. I can press the pedal to the floor and it will accelerate at moderate speed. The engine RPMs never go high as though I'm not pressing the gas pedal hard enough. The ignition module is new, as is the plugs and the wires seem to be good. I have spark from all coils. It also has a sluggish start like the battery is low, but all seems to be fine there.
Any help would be appreciated. |
|
#2
|
|||
|
|||
|
Re: No acceleration
Check fuel pressure at the rail, suspect blocked cat also.
__________________
|
|
#3
|
||||
|
||||
|
Re: No acceleration
Replace your fuel and air filters, and pcv valve If you haven't done so in a long while. Try to clean the throttle body, too.
__________________
![]() http://www.cardomain.com/ride/2653398 1992 Buick Park Avenue (Daily driver) 2001 Saturn SL1 (gas saver)
|
|
#4
|
||||
|
||||
|
Re: No acceleration
Thanks for the replies, the air &fuel filters are ok. I'll check the rail pressure tomorrow.
|
|
#5
|
||||
|
||||
|
Re: No acceleration
What would be a good way to test the fuel regulator without a vacuum pump. Also my security light comes on if i hit the gas hard enough
|
|
#6
|
||||
|
||||
|
Re: No acceleration
Hay GM
I would look at your slow starting. It sounds like a bad conection somewhere. I would look for voltage drops. Clean ground conections. Finding this problem "may" lead you to your accel problem. Regards Dan
__________________
******************************************* Wiswind's Windstar repair pics http://community.webshots.com/album/201931518cScpNK Photos of my repairs: http://dansautopictures.shutterfly.com/ Check this out:http://threewheelmotorcyclemetro.shutterfly.co A must read about problems Windstars have: http://www.automotiveforums.com/vbul...d.php?t=672854 95 Windstar 240,000+ 98 Windstar 136,000+ 09-25-2008. 85 Dodge 1 Ton Snow mover gas hog 91 Mazda Protege free beater SW MN |
|
#7
|
||||
|
||||
|
Re: No acceleration
I found out that the connection to the alternator was loose. Now I'm assuming that it's the transmission starting out in a higher gear.
code 26: shift problem code 31: neutral/safety switch code 56: quad b |
|
#8
|
|||
|
|||
|
Re: No acceleration
Could be a trans solenoid here if it is starting in second or 3rd. Make sure the connection at the trans is clean and tight take it off and look for any corrosion first.
__________________
|
|
#9
|
||||
|
||||
|
Re: No acceleration
I think that i have to deal with neutral start switch telling the pcm that the tranny is in a different gear, causing the wrong solenoid to activate.
|
|
#10
|
|||
|
|||
|
Re: No acceleration
Easy to tell get a scanner on it.
__________________
|
|
#11
|
||||
|
||||
|
Re: No acceleration
I'm obd 1
|
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|