Help with rear ABS Sensor!

[jcb18]

2eyefishclaw, thanks for the interest in my troubles. Yup, the ABS light was on. About the hole in the center of the sensor. I'm pretty sure the black ring that that is the lip of the hole in the middle of the sensor is a grommet of some sort, meant to seal the hole around the sensor. The sensor post itself looks like it may have sheared off somehow.

[MT-2500]

Originally Posted by jcb18

When I had the differential cover off I wasn't able to see back behind the gears, much less reach in there. I might try to break it up with a punch and pull it out in pieces. It's magnetized, right? So I should be able to pull out the pieces with one of those magnet on a stick things?

The end of it has a small magnet on it but the rest of it a lot of hard plastic and electrical stuff.
You may be able to break it up and blow it out or pick it out.
Good luck
MT

[jcb18]

Well if it's mostly just hard plastic then I have what is probably a pretty off the wall idea. Feel free to laugh/ridicule/etc.


Step 1: Wine bottle opener corkscrew into the plastic

Step 2: Pull

Step 3:

[MT-2500]

Originally Posted by jcb18

Well if it's mostly just hard plastic then I have what is probably a pretty off the wall idea. Feel free to laugh/ridicule/etc.


Step 1: Wine bottle opener corkscrew into the plastic

Step 2: Pull

Step 3:

Anything that works goes.
I have even pulled some out with the wire that goes into them.
Good luck
Mt