|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
09-08-2006, 11:51 AM
|
|||
|
|||
|
94 lumina ac
the clutch on my ac is making a rattleing noise and I want to bypass the ac with a different atl belt. is there a diagram to show how this could be done and do you know what size belt it would take? I currently use a 71 inch belt
|
|
#2
09-08-2006, 12:28 PM
|
||||
|
||||
|
Re: 94 lumina ac
Why not just replace the clutch?
The label under the hood showing the belt routing should show the alternate routing for a non-AC vehicle. At least most of them do.
|
|
#3
09-08-2006, 12:38 PM
|
||||
|
||||
|
Re: 94 lumina ac
due to the way the belt routes, you cannot just remove and by-pass the A/C compressor on your car. Any attempt to do so will cause the water pump to spin backwards which will overheat your engine. Dorman makes a kit that includes a pulley and bracket that bolts to the compressor mounts that runs about $30-$40. Part number is 34196. Here's a link to the part on Dorman's website. I did one on a 96 Century, and I had to get new bolts and nuts to attach it, as the bracket has straight through holes, and the compressor has threaded holes so the original bolts were too short.
http://www.dormanproducts.com/cgi-bi...ist=1296:358:0
__________________
 Still waiting for the "good old days" I'll get to bore my future grandchildren with!
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
